Honda Talon Forum banner
1 - 3 of 3 Posts

2 Posts
Discussion Starter · #1 ·
Hi all, I'm about to add portals and I had previously cranked down my shocks to gain a little ride height. I want to put them back to factory ride height. Of course I can not remember where in the heck the piece of paper I wrote down the measurements for the stock settings is.馃ぃ

Could someone be so kind as go measure your stock 1000R front and rear shock distances from where the threads start at top of shock and end at the spanner lock rings?

Or I would settle for number of threads on main body showing.
Remember, front and rear are different.

Thanks so much!!!
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.