Honda Talon Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
28 Posts
Discussion Starter · #1 ·
HELP! My steering wheel is stuck in the up position and will not budge........I tried WD40 on the cylinder, nothing. It's difficult because I am only 5 ft and it puts the wheel right in my line of vision. Hubby is 6 ft, so no problem for him, but....I need it to work. Any ideas please on what to do to unstick it? Thanks!!
 

·
Registered
Joined
·
28 Posts
Discussion Starter · #4 ·
I took a small straight screwdriver and held it against the small tab on the right, and gently pushed in while gently pushing the black knob, just to "unstick" it. I also used WD40 on that same spot (had previously used on cylinder just in case). After a few wiggles, it was persuaded to move and work again.
I suspect it had been pushed a little hard putting in the up position, maybe a little dusty and was left in that position for a couple weeks.
Sure is great to have it working, was like trying to steer a tractor steering wheel when you're too short, haha! Good Luck!
 
1 - 4 of 4 Posts
Top