[Seanhero90]

Hey yall! Looking for light bar mounts for the front of our roll cage. Don’t want to drill through the roof. Thanks in advance !

 

[FOX831]

I did the Honda rooftop light bar, very expensive, although it has taken a beating from tree branches. It is still going strong after 4 months of very snug trails! The power wire on the side could be better protected. The Honda accessory clamps did not line up correctly, manufacturing missed the hole alignment by about 1/16" of an inch, fixed it myself. The clamps that attach to the light bar seem odd also. Lights-up the night very well, good for x-ray of trees! Side note... need rear view light and dome lights!!

 

[BlueDog1210]

I did the Honda rooftop light bar, very expensive, although it has taken a beating from tree branches. It is still going strong after 4 months of very snug trails! The power wire on the side could be better protected. The Honda accessory clamps did not line up correctly, manufacturing missed the hole alignment by about 1/16" of an inch, fixed it myself. The clamps that attach to the light bar seem odd also. Lights-up the night very well, good for x-ray of trees! Side note... need rear view light and dome lights!!

Below is a picture of mine I had to make my bracket to attach to the rear roof bolts as I did not want to cut any holes. All working well. Also used aftermarket bracket for the single row led and the two on the front. I fabricated the wiring and installed the switched next to the factory light switch.

 

[Brussian88]

I apologize for the pics but I only have pics of the light bar installed after I wrecked it I used rzr light mount brackets and bolted threw existing roll bar holes. Only problem is you can’t install a full windshield cause it will hit.

 

[Brussian88]

Here is pics of the mounts and lights I used

 

[peekaa]

Here is pics of the mounts and lights I used

Im looking at the same lightbar on amazon. Did those brakets you used mount it above the roof or below it? Did they mount in the stock holes in the frame ?Dont like limiting my visabilty or rear seat passengers...
Thanks pk

 

[Bronco]

Hey yall! Looking for light bar mounts for the front of our roll cage. Don’t want to drill through the roof. Thanks in advance !

 

[Bronco]

20 k, x 40" light bar (cree)) lights, welded custom brackets, crossbraced entire cage, instrument pod relocation. uses stock half window, full window, stock roof, etc.