Honda Talon Forum banner
1 - 6 of 6 Posts

· Registered
Joined
·
183 Posts
Heating the grease in the bearings from welding can be problematic at times! And if/when the bearings fail someday it will take extra effort to grind off some of the welds without weakening the yokes. I can appreciate what you are trying to accomplish, but extreme care is needed when welding up such areas on a you joint.
 

· Registered
Joined
·
12 Posts
Discussion Starter · #5 ·
Heating the grease in the bearings from welding can be problematic at times! And if/when the bearings fail someday it will take extra effort to grind off some of the welds without weakening the yokes. I can appreciate what you are trying to accomplish, but extreme care is needed when welding up such areas on a you joint.
And that is why the Honda Dealer did the welding and not I. 👍😊
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top